LOblOlly and slash pines are free from such drawbacks, and their growth will far exceed longleaf for several . About one -half of them also contained three shortleaf pine plots. Southern Yellow Pine lumber is referred to commercially as “Southern Pine” or “Southern Yellow Pine”, and four principal species of the Southern Pine species group make up 90% of the Southern Pine timber inventory. Therefore, this article compares only slash and loblolly performance. All planting was by hand at a 6- by 6-foot spacing. Loblolly pine is the most commonly planted, with limited acreages of shortleaf pine, slash pine, and longleaf pine planted on appropriate sites. Longleaf pine stands once covered an estimated 37 million hectares: 30 million hectares of longleaf dominant stands and 7 million hectares of longleaf in mixed-species stands [9]. The longleaf pine (Pinus palustris) is a pine species native to the Southeastern United States, found along the coastal plain from East Texas to southern Maryland, extending into northern and central Florida. pine (Pinus palustris) ecosystem to loblolly pine (Pinus taeda L.). On poorer, drier sites, the longleaf will be a lot taller. Much of the slow early growth of longleaf pine can be attributed to time spent in the grass stage. are two species of southern pine … and longleaf pine (Pinus palustris Mill.) It reaches a height of 30–35 m (98–115 ft) and a diameter of 0.7 m (28 in). Longleaf pine may be preferred if high-quality sawlog and pole production is the primary objective. These pines can also create pine hybrids with other species that are common in the southern states of the U.S. such as the longleaf pine and loblolly pine. Longleaf vs Loblolly and Slash Pines . Southern Yellow Pine Lumber Species Groups. However, today only about 1.2 million hectares of this ecosystem remain [10]. to many years after establishment. In Study 2, stocking ranged from 1,907 longleaf to 2,356 slash pines per ha. Put a loblolly and a longleaf pine together on a typical site, and at 20 or 25 years, they'll be about the same height. How to Tell the Difference Between a Short & Long Leaf Pine Tree. Slash (11.2 m) and loblolly (10.8 m) pine trees had similar average total heights, and both were taller than longleaf pine (9.2 m). In the past, before extensive logging, they reportedly grew to 47 m (154 ft) with a diameter of 1.2 m (47 in). Shortleaf pine (Pinus echinata Mill.) In no case has longleaf or shortleaf pine outgrown in height or out yielded both slash and loblolly pine. These are loblolly, shortleaf, longleaf and slash pine. Pine tree identification Slash pines grow to between 60 and 100 ft. (18 – 30 m). If maximum fiber yield is required, loblolly or slash pine might be favored. plots each of slash, loblolly, and long- leaf pine.